Stair solutions for your home

Our stairs can be made from all of our parquet floors with open and closed sides alike.

The stair edging is made from a single floorboard. The floor’s click system allows a further floorboard to be clicked on to complete the step. This is done on location during assembly.

The steps are entirely prefabricated elements manufactured using precise measurements or templates. We will manufacture your stairs entirely according to your needs, from the same wood type, surface and colour, in line with your individual measurements and to match your parquet floor. These ready-to-install steps then need only to be glued into place.

Our steps are made to measure and are available with side edging. Further installation on site is only provided with Type E. Completely prefabricated block steps are also possible on request.

For the prefabricated Type D and F stair steps, a side edge can optionally be made and installed flat or in two layers. In all other types, a wear layer strip in the right height can be supplied for on-site assembly. This is required, for example, on self-installed stair edges (Type A, B, C) and in the prefabricated Type E step.

We produce the wear layer strip – from the engineered parquet you choose – for you in the height you desire (max. height approx. 70 mm).

You can get risers from us as a white 2 mm PVC board with a slightly textured surface which is easy to clean and extremely resistant. On request, it is also possible to produce the riser from a parquet floorboard including side edge.

Winding stairs can also be supplied as prefabricated steps based on precise measurements on location.

Alternatively, we recommend the use of our stair edges (Type A, B, C) for winding stairs. In this case, an oversize is used and the stair edge is fit in on location. The floorboards for further installation are then also adapted and clicked in. This enables very precise adjustment of the stairs to the conditions on site.